I take it you are talking about the Ford 172 Red Tiger Engine ? I check measurements to put an "N" in it. To get it in I would had to cut and modify the frame. Down at the oil pan level you only have a 14.5 inch clearance. While I could do that I would prefer a bolt in job. I had been told of serval engines that could be made to work. But no one I found could tell me what it would take to get it in. The guy I got the tractor from wanted to put in a 6 cylinder Toyota Diesel engine. Some one had told him that would work. Maybe so, but sounds like it would have been over powered to me. And no telling what it would take to get it in. From what I've been told to do Dozer work the main thing you need is a 'Step Down" Transmission.
Fast Shipping! Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.