The "alligator belt lacing" is usually done with a "Belt lacing device" that looks like a short vise, connected at the bottom pivot (just like an alligators hinged mouth). some fit in a bench vise, other are poundable type. These devices hold the "alligator clips" in line, by the use of a steel removable pin thru them. Most also hold the clips at the right depth to the belt. Both ends of the belt are done with this device and then a nylon pin (doubled over at ends, so it doesn"t slide out)holds the intermeshing alligator clips together. You can probably buy one of these "Belt lacing devices" by searching on line, but I would recommend that you contact your nearest Gas and steam club (or members" to borrow one,
Fast Shipping! Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.