Posted by JCinKY on December 25, 2012 at 13:20:51 from (184.108.40.206):
Merry Christmas to all...I hope all your holidays are full of joy.
I've been working on a 50 front mount that was converted when we bought it. The motor was locked and it didn't run. Just finished the motor and have no spark.
I replaced the wiring per JMORs diagram for a Delco 1 wire alt, minus the lights. I have 12 volts to coil with key on, 0 key off. 12 volts to points with key on and 12 volts to breaker plate with points closed. 12 volts to secondary with points open about 2 with points closed.
I have tried two set of points and two condensers with no change. The ballast glows red hot with points closed, but not with points open. Im at a loss, any help is appreciated.
Fast Shipping! Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.