Wade........its NOT yer squarecan coil its yer carbon core (glass) sparkie wires. They BREAK inside the insulation from handling. Gitt some real COPPER CORE sparkie wires (cut to fit)
You do know ittza 2-bolt, 15-min job to replace the points (0.015") on the kitchen table, don't you? Just un-snapple yer capple and letter dangle. Remove yer 2-bolts and take a walk to the kitchen. Installation is a reversal of the removal ...except... finger start the 2-bolts and put the rotor on. Now rotate the rotor so the OFF-SET tang fits the OFF-SET camshaft slot. Now tighten the 2-bolts and re-snapple yer capple. Simple, eh?
Because yer weird 4-nipple frontmount dizzy has an OFF-SET drive scheme, you can NOT install it outta time.
Remember to "polish" the INVISIBLE corrosion from between the points (0.015") after installation. Me? I clamp a clean $1-bill between the points and pull. Iff'n yer really cheap, tear a strip from HEAVY brown grocery sack and use that. .........Dell, yer self-appointed sparkie-meister
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Fire in the Field A hay fire is no laughing matter-well, maybe one was! And a good life-lesson, too. Following World War II many farm boys returned home both older and wiser. One such man was my employer the summer I was sixteen. He was a farmer by birth and a farmer by choice, and like many returning soldiers, he was our silent hero: without medals or decorations, but with a certain ability to survive. It was on his farm that I learned to use the combination hand clutch and brake on a John D
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.