Posted by 1951 8N on November 19, 2012 at 18:59:43 from (139.55.253.58):
In Reply to: New Project posted by russb wa on November 18, 2012 at 17:36:04:
JCinKY said: So I drug in another mutt 8N today. Dads been looking for one to bush hog with and this one came with a 5' cutter and 6' blade. Its been converted to 12v but currently doesn't run, wiring is a mess. I'll be needing those famous JMOR diagrams.
Serial number 248321, governor has proofmeter attach but wrong dash and no gauge. Got the one piece cast shifter and one hat and one six loop Ferguson wheel. Even has a newer Massey op gauge, kinda cool looking but has to go.
My question concerns a small 3/4"(?) hole in the bell housing right behind the air cleaner close to the battery tray. Haven't been around one with the timing cover, but this can't possibly be for timing. Any ideas???
I'll put some pics up over the holiday.
Why do you call it a mutt? Serial number 8N248321 would be a front mount distributor. Only side mount distributor tractors had the proofmeter from the factory. The one piece shifter would be original too. The hole in the right side of the bellhousing may be from a Hupp or F&T transmission. It either has one or had one at one time maybe.
This post was edited by 1951 8N at 19:00:01 11/19/12.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: 1964 JD 2010 Dsl - Part 2 - by Jim Nielsen. Despite having to disassemble the majority of my John Deere 2010's diesel engine, I was still hopeful I could leave the engine-complete with crankshaft and camshaft-in the tractor. This would make the whole engine rebuild job much easier-and much less expensive! I soon found however, that the #4 conrod bearing had disintegrated, taking with it chunks of the crankshaft journal. As a resul
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.