HR, If I were going to make bushing to fit the wrist pins, I would not use the supplied bushings. Here is what I would do. First I would study the rods with a test bar to see if I could find any "unsquareness". You need to be pure of thoughts when pondering "truthiness".
If I were satisfied that the holes were parallel I would proceed as follows: Start with a bronze bar about 1/8 diameter larger than your finished od. Chuck with enough metal hanging out for ~3 bushings. Drill to within 1/8, bore to three thou undersized and "almost" finish with a brake cylinder hone.
Oh, you have to sneak up on your fits. You'd need to make up a "go, no go" bar with steps, to check yer hole and a sharp cutting tool with a small nose radius for boring.
Then turn and polish the outside to fit. Sneak up on the final fit checking with a stepped gage that you bored before starting. Then cut two bushings out of the middle length, discarding the ends, which are going to be bell mouthed from the hone.
Have to do the above twice.
Cut a five thou releif in the center of each bush about 20% of the length. That way the center can't be high, rocker.
You should at this point be about 5 ten thou under. Finish with made to fit soft aluminum or brass lap and fine compound, or a dowel and micron paper.
Much of the modern world is working off numbers. Many old time machinists did first class "fitment" without bothering to know exact dimensions.
You'd definately want to watch the side clearance on each rod when assembling the engine, well any engine. Check at 90 degree increments, feeler gauges if unsure.
You will be money ahead to pay the automotive machine shop to hone the bushing you already have.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Oil Bath Air Filters - by Chris Pratt. Some of us grew up thinking that an air filter was a paper thing that allowed air to pass while trapping dirt particles of a particles of a certain size. What a surprise to open up your first old tractor's air filter case and find a can that appears to be filled with the scrap metal swept from around a machine shop metal lathe. To top that off, you have a cup with oil in it ("why would you want to lubricate your carburetor?"). On closer examination (and some reading in a AC D-14 service manual), I found out that this is a pretty ingenious method of cleaning the air in the tractor's intake tract.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.