Posted by John in MIch on November 11, 2012 at 15:46:08 from (22.214.171.124):
In Reply to: 2N Runs bad posted by flembo on November 11, 2012 at 11:48:20:
My one 2N has not been started in quite awhile (3 years?) It had no spark so I pulled the dist. and plugs, al437. I set gap and timing but then found that the gap varied from one cam lobe to the next. Wha....? On closer examination I found that the dist. shaft bushing under the rotor was worn. Time for a rebuild. Meantime, I pulled a dist off another tractor that has not been run in awhile. Put it on the bench to check it out and put it on the 2N. AH! Got spark. Now fuel issue. Old gas and probably need a carb cleaning. The hood comes off tomorrow to make things a little easier to get at stuff. I put two gallons of the old gas in my almost full PU tank and two in wife's car also almost full. Help or hurt mileage? Oh well.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.