Posted by old on November 01, 2012 at 09:21:20 from (209.86.226.40):
In Reply to: 2N in frame? posted by Gustafson on November 01, 2012 at 06:34:00:
If rusted much of any a full rebuild will need to be done because you will not be able to hone out all the rust pits. Sort of makes me think about a Honda 50 I had back when I was 16 or so. The cylinder on it was so bad a set of rings would last maybe a week or 2. Replace the rings every week or so till the rings cleaned up the cylinder and all was ok for a long time. Bet I put in 4 or 5 sets of rings before the cylinder cleaned up enough for the rings to stay in but back then a set of rings and the gaskets I needed cost less then $10
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Madison's County - by Anthony West. Philip Madison has been a good friend of mine for quite some time. He has patiently suffered my incessant chit chat on the subject of tractors for longer than I care to remember, and on many occasions he has put himself out, dropped what ever it was he was doing, to come and lend a hand cranking handles, or loading a find onto a trailer. Although he himself has never actually owned or restored a tractor, he was always enthusiastic and always around helping with other peoples projects.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.