Posted by TheOldHokie on November 01, 2012 at 08:14:58 from (220.127.116.11):
In Reply to: 2N in frame? posted by gracepat on November 01, 2012 at 06:34:00:
Quoting Removed, click Modern View to see
If skills are "moderate at best" I'd suggest a shop. Use it as a chance to develop your skills a bit while doing some of the preliminary disassembly. Remove the engine and strip it the bare block. Remove the oil pan and take a peek inside before you hand it off to the pros. Expect a bill for roughly $1500 when you get it back.
Fast Shipping! Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.