Posted by Mr. T. Minnesota on October 23, 2012 at 15:59:19 from (68.170.114.158):
In Reply to: Re: 49 N charging posted by Bruce in 100 mile house on October 23, 2012 at 10:49:38:
100 mile Bruce,
My 2N does the same thing. It seems slow to charge.I replaced the belt with a ribbed belt and it did not really help. Tightness can be a problem as mentioned by another forum member. I run an old Wincharger system at my man cave in northern Minnesota and have worked on 6 volt generators for about 50 years give or take. You mentioned the tractor has seen a lot of use so your commutator may have to be cleaned up a bit. The spaces between the copper bars used to be mica.The spaces may have to be cleaned if the copper has worn down riding more on the spacing material than on the commutator bars. I cleaned one of my Wincharger generators and it helped a lot. Hope this helps! Mr. T. Minnesota
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - It Can't Be Done! - A Tractor Story - by Neil Campbell. I'll never forget the time back when I was a boy baling hay on our Farm in Big Rapid, Michigan. The most memorable event that took place was a trip up the steepest incline on the farm pulling an old New-Idea baler with a pony-motor for power and a haywagon. I had just talked my Dad into buying an old John Deere B with 6-speeds ahead and I was real proud of it, except it was a little smaller than the Case tractor that we normally
... [Read Article]
Latest Ad:
Rebuilt Injection pump for J D 1010. Call or text for pictures or more imformation.free shipping.U.S. No core charge
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.