Takes somewhere between 16 and 18 quarts..remove bottom bolt from inspection cover where dipstick is located--fill it till it runs out of this hole..won"t show quite full on the dfipstick but don"t worry about that....whwn draining it remove the rear most plug--it is the smallest hole so you will be able to aim it in a bucket better and get most of it drained from there(3 gal or so)..then remove the next plug which is in the pump, then remove the next plug which is basically in line with the shift lever..let it drain till U know it has all drained out--overnight is good but not necessary..replace all three plugs and fill through the big plug hole by the shift lever.....Hope this helps Depends on where you are but original oil was GL-1 90 wt mineral oil 134 is thinner so if U are in a cold climate it will warm up and the hydraulics will work smooth faster but in hot climate the 134 is more likely to leak if you have leaks anywhere....
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: Modern Diesel Fuel in an Old Tractor - by Staff. This interestin discussion is from the Tractor Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Rebuilt Injection pump for J D 1010. Call or text for pictures or more imformation.free shipping.U.S. No core charge
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.