Gaspump said: (quoted from post at 13:36:43 12/12/09) Don't have to. I have done several with the JB only to soon repair it again. When the manifold is removed with JB repairs you will have some dust falling off with the gasket and the repaired pits will be clearly visible. The Thermo will be just as when you installed the manifold or even better as it seems to continue to harden and even look more like the block metal. As you can see I am not a big fan of JB, it is great in many applications but especially not for block pits. I get all the JB products from one of our sponsors and I have tried them all as recommended. There are at least 6-7 different JB welds, you may have used something other on your block pits than the original or their Hi-Temp as I have, there is no comparison to the Thermo results.
Based on your results, I would assume you did a poor job on the prep. Had my manifold off last year to do a valve clean up and the JB was as good as when I put it on.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Fire in the Field A hay fire is no laughing matter-well, maybe one was! And a good life-lesson, too. Following World War II many farm boys returned home both older and wiser. One such man was my employer the summer I was sixteen. He was a farmer by birth and a farmer by choice, and like many returning soldiers, he was our silent hero: without medals or decorations, but with a certain ability to survive. It was on his farm that I learned to use the combination hand clutch and brake on a John D
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.