|
Ford 9N, 2N & 8N Discussion Board |
Fix for sticking clutch
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by John.COLO on January 20, 2006 at 08:13:02 from (67.177.251.131):
Seems like there are always threads about Ns with the clutch disengaging erratically, if at all. Several things cause this; lack of regular use, gummy oil on the clutch plate from a leaking seal in transmission, moisture leading to rust. The correct solution is to split the tractor and repair/replace the issues. Participants on this site often look for shortcuts to avoid the work and expense involved in the full repair...block the pedal down, drag the brakes, drive tractor into a tree, etc. I've found a shortcut fix that works better than all others. Brake cleaner sprayed on the clutch plate and flywheel will cause the clutch to function properly without sticking. First, the clutch must be disengaged. Heat is the best aid I've found. In lieu of a hot summer day, I direct the heat from my salamander jobsite heater at the bell housing with the clutch pedal blocked down. If the clutch doesn't spontaneously release I may need to start the tractor in gear and drag the brakes. I drill a 7/32" hole into the bell housing on the right side about 2" back from the parting line at about the 2:00 O'clock position. Using the little tube supplied with the brake cleaner can I spray fluid into the compartment in the direction of the back of the flywheel. With the brakes locked on I do this with the engine running and the clutch pedal depressed, then ride the clutch for a couple of seconds. This creates heat and friction on the clutch disk and aids the clutch cleaner to work the guck out of the clutch disk. Be sure the drip hole in the bottom of the housing is open because alot of nasty stuff runs out. I repeat this time and again until I've used the entire can of cleaner. When finished I tap my 7/32 hole to 1/4"x20 and close the hole with a stubby machine screw. This method has worked every time I've used it. Best regards, tOTG
Replies:
Home
| Forums
Today's Featured Article -
It's Alright Where It Is! - by Anthony West. I have a tale of a different kind to tell. Whilst rooting in the hedge bottoms this week I had cause to visit Chapel lane Farm, the home of an eccentric gentleman by the name of Austin Kendall. I had heard rumours that an old Case Model C was languishing away in the back of one of the outbuildings there. So off I went in search of what would turn out to be a very rare and unusual tractor. Mr Kendall is an excitable chap to say the least. He is amongst the last of a dying breed of farmer who
... [Read Article]
Latest Ad:
Super WD9.
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
