Ford 9N, 2N & 8N Discussion Board |
Re: Re: 8n starter install
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Jeb2N on November 10, 2003 at 13:50:28 from (65.40.234.137):
In Reply to: Re: 8n starter install posted by Enumclaw on November 10, 2003 at 13:30:57:
I must have gotten lucky or the 2N's are built differently, but my flywheel housing and starter hole are factory egg-shaped to allow you to move the starter bendix off of the flywheel and then pull it out at a slight angle towards the engine. I can see no grinding marks as if it were homemade, and it is perfectly symetrical, so I assume that it was done at the factory. I was pleased with how easily mine pulled out. All I can suggest is to just keep wiggling it until it evenutually comes out. And Obviously angle the free end of the starter towards the engine.
Follow Ups:
Home
| Forums
Today's Featured Article -
Hydraulic Basics - Part 2 - by Curtis Von Fange. In the last entry to this series we gave a brief overview of hydraulic system theory, its basic components and how it works. Now lets take a look at some general maintenance tips that will keep our system operating to its fullest potential. The two biggest enemies to a hydraulic system are dirt and water. Dirt can score the insides of cylinders, spool valves and pumps. Wate
... [Read Article]
Latest Ad:
Super WD9.
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|