Ford 9N, 2N & 8N Discussion Board|
8N Draft Control
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by jerry.in.ga on August 21, 2002 at 12:34:16 from (22.214.171.124):
I used my bottom plow this morning with the lift in the draft (horizontial) position. The draft worked great. However, the plow would not raise out of the ground when the lift lever was in the up position. To get the plow to raise, I had to put the draft control lever in the vertical position. The plow would then raise out of the ground, then make the turn, put the draft control lever back in the horizonital position (a pain). Is this normal procedure? I was thinking that even in draft mode when the lift lever was raised to the fully up position, the implement should raise. Insight is appreciated.
|Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]|
| Copyright © 1997-2013 Yesterday's Tractor Co.|
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters