Ford 9N, 2N & 8N Discussion Board |
Re: Re: Re: Re: Utility Box for 3 point hitch....
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by AB on May 23, 2002 at 05:42:13 from (32.97.110.66):
In Reply to: Re: Re: Re: Utility Box for 3 point hitch.... posted by Dave Manley, NY on May 23, 2002 at 04:11:08:
The width of the frame is such that the lift pins are the same as would be for a standard cat 1 draw bar. That will allow you to use your stabelizer arms. Think the depth of the frame to be about 36". Wish the inside depth of the box was a couple inches bigger! Twenty years ago when I built it I didn't burn wood. Have to leave the endgate out to haul two rows end to end. If ya build one keep in mind your inside size requirement and go from there.
Follow Ups:
Home
| Forums
Today's Featured Article -
Farmall 460: That's My Girl - by LeAnn R. Ralph. How many sounds can you think of that are as familiar to you as your own breathing? What about the hum of your refrigerator? Or the thump of your clothes dryer? Maybe the engine of your car? You hear those sounds every day, and you don't think much about them, do you. I can think of a few common, ordinary sounds in my daily life, too.
... [Read Article]
Latest Ad:
Super WD9.
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|