|
Ford 9N, 2N & 8N Discussion Board |
#3 Cylinder not working
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Danny in CO on September 18, 2000 at 09:21:09 from (192.94.201.70):
I have a problem with my #3 cylinder in my '48 8N. I pulled the plugs on all cyliners. #3 plug was covered with crud, not firing. I checked dry compression: #1 90#, #2 90#, #3 75-80#, #4 90#. I didn't do a wet check yet. That's my next step. Put new plugs and wires on. Pulling the wire off #3 plug has no effect. Spark at #3 is OK. I am now suspecting a stuck valve on #3. I tried running automatic transmission fluid through the carb to try and un-stick the valve. It seems to have helped a little. Any suggestions?
Follow Ups:
| Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ] |
Home
| Forums
Copyright © 1997-2013 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor Headquarters |
About this site - Yesterday's Tractors is your one-stop source for antique tractors. If you are interested in older tractors you've come to the right place! Join more than 275,000 other classic tractor enthusiasts from all over the globe. We have many resources for antique tractor enthusiasts available including photos, classified ads, more than 24 tractor discussion forums, a show guide, values, specs and much more. Bookmark this site and come back often. Thanks for stopping by! Feel free to use our feedback form to send us your comments, suggestions and ideas.
|
|
