Posted by shinnery on November 06, 2013 at 23:21:31 from (216.189.201.78):
In Reply to: MM670 fluids posted by bshadrake on November 05, 2013 at 09:11:14:
My 445s, 4Star, and M-5s with tel-o-flo hydraulics, you are expected to pull the plate with the Rate and Cycle levers on it to check Hyd. Fluid levels. I have modified them to be like my M670 but have not come up with a dipstick. I bought a 3/4x1/2x3/4 tee and a 1/2" close nipple to replace the drain plug in the housing and then put a 6-8" 3/4" pipe in one end of the tee to get the fill point above the running level, I also got a 45 deg. 3/4" street ell to get the drain away from the tractor then used a 3/4" pipe plug as the drain.
The hydraulic level is supposed to be within an inch of the top of the housing where the levers are mounted. I just use a screwdriver down the pipe to check the fluid level and eyeball the front of the housing. Works for me.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Madison's County - by Anthony West. Philip Madison has been a good friend of mine for quite some time. He has patiently suffered my incessant chit chat on the subject of tractors for longer than I care to remember, and on many occasions he has put himself out, dropped what ever it was he was doing, to come and lend a hand cranking handles, or loading a find onto a trailer. Although he himself has never actually owned or restored a tractor, he was always enthusiastic and always around helping with other peoples projects.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.