Posted by LW on May 12, 2013 at 04:21:32 from (220.127.116.11):
In Reply to: speed posted by greg herriott on May 06, 2013 at 19:08:56:
Greg, Same Ring and Pinion and other gears, The did have a split counter shaft that could be put out of mesh. The ring and pinion is the same as red nose and other early U's. Its a 2.52:1 ratio, I think the Overide assy was simply a governor bypass/overide and the engine had to turn over governed RPM to achieve the higher mph. Mathmatically at Governed speed of 1200rpm only puts them at about 23-25mph
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.