Posted by 6pack on February 05, 2013 at 14:20:26 from (220.127.116.11):
In Reply to: pulling motor posted by big Mo on February 05, 2013 at 00:10:30:
If you are looking for a crank, I have one 7.625" I have not decided if I am gonna use it or not.... I might stay at 7.00-7.25...
It was welded by Jeff @ Stamm Equipment, and never used. Now for the bad news... It will need to be re ground as it was set up for U rods which will not work!!! Would have to do a custom rod... Give me an email address if interested, can send some pics too... This crank cost $2500 originally!
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.