Posted by c leddy on January 21, 2013 at 20:03:25 from (174.74.54.243):
In Reply to: MM loader specs.. posted by Alan K on January 16, 2013 at 07:30:04:
I had a chance to measure my bucket which is almost the same shape as yours and what i found is the bucket pins at the end of the arms is 8.25" cd off the ground when it is flat. The bucket cylinder pin is 9.5" cd from the lower bucket pin. Upper cylinder pin is 35.50"cd from lower bucket pins and the cylinder stroke is close to 17" all the way extended. With this set up the bucket tips back 20 degrees and dumps 10 degrees past 90(straight up&down) when the bucket is lifted enough for the edge to be off the ground. If this helps I could actually measure the cylinders retracted and extended and you could play with string and a little geometry and try different things. With shorter cylinders you aren't going to get that much dump angle but how much does a person really need??This post may be old so hope this helps now.Cleddy
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Fire in the Field A hay fire is no laughing matter-well, maybe one was! And a good life-lesson, too. Following World War II many farm boys returned home both older and wiser. One such man was my employer the summer I was sixteen. He was a farmer by birth and a farmer by choice, and like many returning soldiers, he was our silent hero: without medals or decorations, but with a certain ability to survive. It was on his farm that I learned to use the combination hand clutch and brake on a John D
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.