What Clint says will work. If you don't weld the screwdriver to the plug (use something real sticky, like a heavy grease. Put some fresh sealer on the edge of the plug) you don't have to leave them in provided you was able to dimple the plug enough. I used a special tool I made for this. After you get it in and crushed as best you can. Take a square nut the right thickness and drive it in place at the center of the plug for added holding power. No one will ever see it.
If you do take the head off. You said you used Copper Coat (that is the best). Wash the gasket off with solvent, dry. Spray Copper coat (allways use the spray, the dobber in the can doesn.t stay mixed and doesen't apply as even.) Coat the gasket. let dry over night, put on a second coat, let dry for a few hours, spray coat again and let get tacky. Put it on and torque the head. You should be fine
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Farmall 460: That's My Girl - by LeAnn R. Ralph. How many sounds can you think of that are as familiar to you as your own breathing? What about the hum of your refrigerator? Or the thump of your clothes dryer? Maybe the engine of your car? You hear those sounds every day, and you don't think much about them, do you. I can think of a few common, ordinary sounds in my daily life, too.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.