Posted by Howard H. on November 09, 2012 at 07:30:44 from (164.58.210.23):
In Reply to: Re: UB 3 pt posted by brian(MN) on November 08, 2012 at 15:53:23:
It looked factory enough to me that I just assumed... Hopefully, Brian Gonyea or LW or Schrocky or someone more knowledgeable than I can give more info.
Brian K, I'll probably hang onto this for a while, but keep looking - they are out there. I'm kicking myself for not seeing one laying on a pallet at an auction a few months ago until after the sale was over.
I was looking at the specs on John Deere's big 4 wheel drive the other day and saw that its 3 pt capacity is 20,000 pounds now!!
That makes this early attempt at a 3 pt seem pretty primitive. Pretty amazing how far things have come.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: 1964 JD 2010 Dsl - Part 2 - by Jim Nielsen. Despite having to disassemble the majority of my John Deere 2010's diesel engine, I was still hopeful I could leave the engine-complete with crankshaft and camshaft-in the tractor. This would make the whole engine rebuild job much easier-and much less expensive! I soon found however, that the #4 conrod bearing had disintegrated, taking with it chunks of the crankshaft journal. As a resul
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.