this was a 283 crankcase with a 403 crank and hd800 juggs and 4233 heads. the only problem i had was the starter drives till i bout a racket type that had rubber in it. it dynoed 170hp and pulled 3rd gear at little over 8mph with a 35000 lb sled. it got so bad pulling with it that all the guys that out pulled me when i had the 403 stopped pulling against me. most pulls it was only me and one other guy. i ran it for almost 3 years with no problem which the best moline man in the south put it together and tuned it. i ran it on propane with a carb off a hd800. it was a man but the guy i sold it to messed with the timing and he busted a jug and piston in it cause of detonation. the last i talked with him he said it was better now but i dont beleive it. i think he messed it up cause he did it right after he bought it cause of not listening to the guy that built it about wanting to change things on it. it only turned 2400rpms.
Fast Shipping! Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.