Massey Tractors Discussion Board |
Re: Re: massey ferguson 135 hydraulics
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bob on November 24, 2002 at 17:28:18 from (24.82.154.233):
In Reply to: Re: massey ferguson 135 hydraulics posted by Mehl Hart on November 24, 2002 at 15:43:25:
Hi Mehl: The first thing you will need to do is to drain the transmission of hydraulic fluid. There are two drain plugs. Then look for the PTO speed selector lever. It is on the left side of the housing that your seat is mounted on. That lever engages a gear to operate the PTO. You will see that there is a cover plate with 5 or 6 bolts that will allow you to remove the cover. There is also a gasket under the cover so be gentle when you remove the cover. The PTO gear selector handle will come off with the cover. The filter is visible -(It sits in the middle, with a metal top and bottom cover) Remove the top cover by turning it counter-clockwise. Then lift out both the bottom cover and filter together making sure not to spill any sludge that may be inside the bottom cover. There is also an O ring that sits on the opening where the filter is installed. Make sure that you don't accidently dislodge this O ring and shove it into the hydraulic pump. It is needed so that the bottom cover of the filter will seal properly when it is re-installed. Clean the filter (If you don't think the filter is cleaning up well buy new one)and the covers with Varsol and then re-install them. Then put the PTO cover back on making sure that the inside portion of the gear selector is placed in the slot so that it will engage the PTO properly, Then re-fill with new transmission oil and hope for the best. Bob P.S. This is assuming that your 1974 is the same setup as my 1970
Follow Ups:
Home
| Forums
Today's Featured Article -
Hydraulic Basics - Part 2 - by Curtis Von Fange. In the last entry to this series we gave a brief overview of hydraulic system theory, its basic components and how it works. Now lets take a look at some general maintenance tips that will keep our system operating to its fullest potential. The two biggest enemies to a hydraulic system are dirt and water. Dirt can score the insides of cylinders, spool valves and pumps. Wate
... [Read Article]
Latest Ad:
Super WD9.
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|