Posted by samn40 on March 23, 2014 at 01:35:50 from (109.157.198.201):
In Reply to: MF 491 PTO shaft leak posted by MarkinMo on March 22, 2014 at 05:29:06:
As far as I know this tractor has the same rear axle as the 200 series Masseys? If so then you need to remove the 4 nuts, washers and the square plate around the PTO shaft There may be another thin plate to keep the bearing housing from rotating, remeve it also. Now fit a drive shaft or place a bolt through the little hole down through the shaft to lever against and use a tyre lever to prise the shaft out of the tractor. It will only be retained with a tight 'O' ring and should prise out quite easily. Remove the bearing housing and a few snap rings holding the assembly together..Refit the special seal and rebuild.........Not need to tear in any further............ Sam
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - It Can't Be Done! - A Tractor Story - by Neil Campbell. I'll never forget the time back when I was a boy baling hay on our Farm in Big Rapid, Michigan. The most memorable event that took place was a trip up the steepest incline on the farm pulling an old New-Idea baler with a pony-motor for power and a haywagon. I had just talked my Dad into buying an old John Deere B with 6-speeds ahead and I was real proud of it, except it was a little smaller than the Case tractor that we normally
... [Read Article]
Latest Ad:
Rebuilt Injection pump for J D 1010. Call or text for pictures or more imformation.free shipping.U.S. No core charge
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.