Posted by DavidP, South Wales on September 23, 2013 at 12:29:09 from (89.168.24.113):
In Reply to: MF 135 Hydraulics posted by Christos on September 23, 2013 at 10:51:39:
Hello Christos, No sooner done than said with the sketch for the MF 163 tool. You should find this image sharper. Before going into any thinking about the isolating valve operation have you checked that the control spring adjustment is correct and that the spring is stiff to turn by hand?
The fact that you have a plough fitted can certainly influence the lift if the/any play in the control spring and yoke is just enough to cause an imbalance on the control lever.
With the DRAFT position lever fully lowered check the yoke for end float. Ideally there should be none. If you have not done so it would be worth removing the CS assembly and making sure that the spring is STIFF TO TURN BY HAND.
If the Pressure Control components have been removed presumably you now have a relief valve fitted in the rear plate of the pump and not the plain plug.
I would want to be sure that the CS is correct before looking further.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: Modern Diesel Fuel in an Old Tractor - by Staff. This interestin discussion is from the Tractor Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Rebuilt Injection pump for J D 1010. Call or text for pictures or more imformation.free shipping.U.S. No core charge
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.