Posted by Michael V (NM) on September 21, 2013 at 09:15:55 from (184.108.40.206):
transmission sticks or hangs in 5th gear, so I take the shifter off, find the top(main) shaft bearings are really bad. ok, gets new brgs, seal w/sleeve, went back together good, main shaft now like new, checked pinion (lower),its still in good shape, now its hung in 5th gear again. whats happening? do I gots a problem with 5th gear overshifting ie going to far in gear? the snap ring groove on the shifter rail goes beyond the front of the guide where the detent /interlock is on front of the trans, do I need to put a snap ring on the shifter rail to prevent this? more problems...I filled the trans/final drive with oil before I found this out...well now found out the axle seals leak really bad. new ones on the way from Kessels...thanks for any help
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.