Hi David , thanks for your reply. I tested the system with a round bale on pallet forks (about 300kg). I did'nt want to spend much time on this job , so I raised the loader, put the right wheel on a concrete block and took the cover off without removing the foot plate. I was having problems feeling around for the adjusting tube so I took some photo's. They say a picture is better than a thousand words and these pictures say a lot. Although I like things to be "in order" and origional, the tractor is mainly for the loader so it's not such a problem. The lift works and goes high enough to latch the pickup hitch. It does however raise a few questions with respect to a relief valve, which assume is fitted. The lift is not as strong as my MF155 which has the same back end so I was wondering if, as you said, some oil is leaking past the ram cylinder or the relief valve has a lower rating. I have heard of this being done and with your experience I'm assume you have also seen such a modification. If so can you let me know if there are things I should check. Mike.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Farmall 460: That's My Girl - by LeAnn R. Ralph. How many sounds can you think of that are as familiar to you as your own breathing? What about the hum of your refrigerator? Or the thump of your clothes dryer? Maybe the engine of your car? You hear those sounds every day, and you don't think much about them, do you. I can think of a few common, ordinary sounds in my daily life, too.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.