Hi Ken, First of all the 3-point linkage does not lower 'under power'. The weight of the lift arms or implement take them down. The slow drop will not be connected to the filter but it is always advantageous to check and clean the filter as you do not know when(if) it was done last. The photos will show the location of the filter. As yours is a 'later' tractor, check on the underside of the rear centre housing and look for a triangular plate. Filters on later tractoirs could be removed via this plate. If you have this type, drain the oil and remove the plate. There is a wire clip to remove and then a nut, washer and spring. The filter will now fall out.If you do not have this type proceed as follows; Photo is of course with the hydraulic cover removed. It is not necessary to do this to remove the filter.
Remove any pipework, hand brake rod, and for better access the left hand footplate. It is advisable to drain the oil completely or at least to the level of the bottom bolt of the LH side cover. Remove the cover. Be careful there are sharp edges. Cut the locking wire and remove it all. You may need a small pair of pliers to loosen and then unscrew the filter. There should be one full cup on top and a shallow cup underneath with an O ring under that. It will probably come out as one assembly.
Clean or replace as required. Suitable electrical copper wire can be used to lock the filter. In 40 years of MF work I have not had one come loose but it's there for a reason. Reverse the procedure and replace the oil etc.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Madison's County - by Anthony West. Philip Madison has been a good friend of mine for quite some time. He has patiently suffered my incessant chit chat on the subject of tractors for longer than I care to remember, and on many occasions he has put himself out, dropped what ever it was he was doing, to come and lend a hand cranking handles, or loading a find onto a trailer. Although he himself has never actually owned or restored a tractor, he was always enthusiastic and always around helping with other peoples projects.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
