I did adjusted the control spring like you said and also installed in back the same way you said.
Yes it lifts the plough clear up the ground where only the ferrow wheel was touching. After lifting, it drops it back 1-2 seconds. Can you please advise more on the bent frame.
Actually the pump frame where the control lever is attached, that frame was bent backwards towards the PTO, I have made it straight. Can it be the problem.
The initial problem with the system was that it was keep lifting and making the relief valve sound. Then the valve becomes stiff and we cant move to release. I changed the control valve and spool only. Should I change the O-rings also.
After I did the changes the pump works fine in lifting and maintaining positions. The only problem is that implement come off the ground with I plough.
Do you feel that I should bend the frame of pump (holding the control lever) like it was.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Fire in the Field A hay fire is no laughing matter-well, maybe one was! And a good life-lesson, too. Following World War II many farm boys returned home both older and wiser. One such man was my employer the summer I was sixteen. He was a farmer by birth and a farmer by choice, and like many returning soldiers, he was our silent hero: without medals or decorations, but with a certain ability to survive. It was on his farm that I learned to use the combination hand clutch and brake on a John D
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.