Posted by fdt860 on April 06, 2013 at 08:46:36 from (68.103.107.127):
In Reply to: Hand clutch on 55 posted by Howard Larson on April 05, 2013 at 20:30:19:
I believe that you need to reinstall the shaft into the flywheel first.
That is not the usual method, but that will work.
The bearing at the end of the flywheel housing is not so tight on the shaft, so it is feasible.
I got a 55 Hand cluthc too, but I have to convert it to foot clutch because parts are impossible to find for the hand clutch version. So mine will be a hand and foot clutch, because I will just drill a hole in the foot pedal to allow using the hand lever.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.