I have been reading this for days... OK, perhaps you- and your freind, have plugs that have a -too large 'runoff', a clearance between the end of the thread and the inside of the hex head. That and too thin a thread in the pan hole... and they aren't meeting each other. Now, just rotating? 'IF' you pry, or preferably pull- the plug head away from the pan- while slowly spinning counter clockwise, to get the threads to engage again? A gool o ring would keep the oil from leaking.... take a razor and cut the o ring? If it is a brass washer...argh... I agree with the theory that... this is impossible! When that sump hits the deck with 2 gallons of oil... you are going to get dirty! Wear your old rain suit and skidoo googles....
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Farmall 460: That's My Girl - by LeAnn R. Ralph. How many sounds can you think of that are as familiar to you as your own breathing? What about the hum of your refrigerator? Or the thump of your clothes dryer? Maybe the engine of your car? You hear those sounds every day, and you don't think much about them, do you. I can think of a few common, ordinary sounds in my daily life, too.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.