Posted by Samuels68 on January 13, 2013 at 12:35:07 from (173.215.11.129):
Here I am again guys, asking for advice cause I am stumped....
My Industrial 20 (3cyl Perkins Gas) seems to have a wiring problem that I can't manage to track down. I have traced every wire (except for the light circuit which is unhooked) and replaced damaged wiring so that everything is complete and matches the diagram.
I replaced the ignition switch because the old one pretty much fell apart when I touched it, and replaced the voltage regulator that was pretty well baked. It appears as if the battery moved in the tray (hold down clamp long gone when I got it) and pinched a wire coming from the regulator, causing a short, and heating which cooked alll the wiring within 2 inches of the regulator, all of which I replaced.
I have a good battery installed and am getting 13+ volts from positive to negative and positive to engine block. I have 13+ volts to the starter wire. However, I have no voltage to the ignition switch, and obviously, none coming out of the ignition to fire the solenoid.
I have not resorted to jumping the solenoid straight from the starter wire for fear of damaging something further, but I am about to that point.
Obviously, I am missing something, but can't seem to put my finger on it.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
About this site - Yesterday's Tractors is your one-stop source for antique tractors. If you are interested in older tractors you've come to the right place! Join more than 275,000 other classic tractor enthusiasts from all over the globe. We have many resources for antique tractor enthusiasts available including photos, classified ads, more than 24 tractor discussion forums, a show guide, values, specs and much more. Bookmark this site and come back often. Thanks for stopping by! Feel free to use our feedback form to send us your comments, suggestions and ideas.
