Posted by Robert major on December 19, 2012 at 15:52:48 from (216.81.1.243):
In Reply to: 1100 Massey clutch? posted by 1100 MF question on December 18, 2012 at 11:28:17:
Hi The 1135 has an inspection cover, it has a greaser in it for the release bearing. a lot of other masseys have plates under the clutch housing, so don't see why not. As the other poster said try it in gear and stand on the Brakes I have done this on a fordson that stuck and it worked for me Just make sure the stop works good, If not ya might need clean shorts L.O.L
Maybe the seals are leaking on the motor or transmission input and oil has stuck it too seen different colors do this once in a while.
I remember an old guy telling me that blocking the pedal down for a long time is not a fantastic Idea as the springs are under a lot more tension and it weakens them over time. Good luck Regards Robert
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulic Basics - Part 2 - by Curtis Von Fange. In the last entry to this series we gave a brief overview of hydraulic system theory, its basic components and how it works. Now lets take a look at some general maintenance tips that will keep our system operating to its fullest potential. The two biggest enemies to a hydraulic system are dirt and water. Dirt can score the insides of cylinders, spool valves and pumps. Wate
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.