Posted by Inno on December 17, 2012 at 20:25:15 from (206.47.249.247):
In Reply to: MF parts source posted by Glenn Archer on December 17, 2012 at 14:05:31:
I've purchased plenty from this site. I think their parts are as good as any out there and their prices are generally better than other places I've looked. I'll buy the occasional piece from ebay if I can find a good used part etc. I figure for all the good advice and conversations I have on this site I might as well support them and keep the forum going.
Many parts available, probably the vast majority are aftermarket from any supplier. Certain things are still available as OE but even the stuff in a Massey box might be made in India, Turkey......who knows where else.
Only thing I ever had problems with was a manifold for my 202 and I can't even remember where I bought it from. It was a very rough casting which required a lot of grinding/filing to get it to fit and so I could tighten up all the nuts properly.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.