OK I stripped an old pump this morning to get you all some pics of how to cure this simple but messy problem....... First pic...remove the tying wire and remove the two nuts on top 2nd pic...remove the nuts and washers and levers from the throttle and strangler shafts 3rd pic...you need to look in and upwards to see where the spring is attached...be very careful as the spring can unhook. (my camera had bother focusing) 4th pic....there are 3 holes on the linkage at each end, this is the front end of the spring and my 135 type had the pin to connect the spring in the top hole. 5th pic...and the spring in the hole closest to the shaft on the back/lever end. Carefully lower the lid back on to the pump making sure the stop linkage is hooked in correctly( Front shaft) Make sure you get a new gasket for the pump body to lid and new sealing washers for the fixing studs and 4 new 'O' rings (2 per shaft) 6th pic. That is about the best I can do for you from this side of the Atlantic! Sam
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - It Can't Be Done! - A Tractor Story - by Neil Campbell. I'll never forget the time back when I was a boy baling hay on our Farm in Big Rapid, Michigan. The most memorable event that took place was a trip up the steepest incline on the farm pulling an old New-Idea baler with a pony-motor for power and a haywagon. I had just talked my Dad into buying an old John Deere B with 6-speeds ahead and I was real proud of it, except it was a little smaller than the Case tractor that we normally
... [Read Article]
Latest Ad:
Rebuilt Injection pump for J D 1010. Call or text for pictures or more imformation.free shipping.U.S. No core charge
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.