Posted by Chuck H in Wi on October 21, 2012 at 15:52:28 from (22.214.171.124):
In Reply to: Pony Clutch posted by pony1952 on October 21, 2012 at 13:32:39:
Bruce, spring on throw out bearing lever engages the pressure plate fingers to work the clutch plate. Did you line up clutch in center of pilot bushing. If it is a new pressure plate sometimes they block fingers until it is installed and you remove spacers before putting motor back in. Let me know how you are doing, not really anything in manual for diagrams to go by. I have had mine apart acouple of times, no problems. I do have parts incase you need something. Good luck
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.