Posted by Inno on October 16, 2012 at 11:36:50 from (206.47.249.247):
In Reply to: Massey 99 loader cyl posted by Thad on October 16, 2012 at 07:22:06:
Not a stupid question at all........and I'm not sure if I have an answer but in looking at one of mine I would think that maybe the end unthreads?
I just took a 99 loader off of a TO-35 I recently bought.
The manual I have only talks about the 2 way cylinder but it does say to remove end cap then tap bearing (bushing) back as far as you can away from lock ring, remove the lock ring. This is for the dump cylinder.
For the lift cylinder it says remove end cap and remove bearing.
It also notes to make sure there is no pressure on the cylinder.......probably goes without saying but it's probably pretty good advice!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Farmall 460: That's My Girl - by LeAnn R. Ralph. How many sounds can you think of that are as familiar to you as your own breathing? What about the hum of your refrigerator? Or the thump of your clothes dryer? Maybe the engine of your car? You hear those sounds every day, and you don't think much about them, do you. I can think of a few common, ordinary sounds in my daily life, too.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.