Posted by Raham on September 09, 2012 at 16:55:28 from (220.127.116.11):
In Reply to: Re: Sickle mower posted by Tony in Mass. on September 08, 2012 at 09:55:35:
I Have all the old bearings but they have been badly rusted. I am currently soaking them in molasses to hopefully revive them. If I do have to reuse old bearings I probably wont be able to use the sickle. I have tried over the counter and whilst I have had a some success I wont be able to get all the bearings I want. Even with the successful ones I will still have to get bushes made up to take up the slack. I have priced brass bushes but at $600.00 just for the brass without the turning the cost will start mounting up.
Fast Shipping! Most of our stocked parts ship within 24 hours (M-Th). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a company you can trust and have generous return policies. Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ About Us ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.