There is no guide bolted to to the gear case cover. I can roll the shifter around in circles when it of off the tractor. In front of the transmission housing, beside the drive shaft going into the transmission, you see a block with a cover that covers the rods or rails. On top of that block there are 3 pipe plugs over each rail. There is a spring and with a ball under it. There are 3 v notches on top of the rails for this ball to set in to hold it in neutral or what ever gear it is in. There is also a round notch on the SIDE of the rails or rods. One on each side of the center rail and one on the inside of the outer rails. My best uneducated guess is that there is a ball, or something, in between the rails that will not allow two rods to be moved at the same time and I would say yours are missing. Take the cover off of that block and look at your rods or rails and you will see what I mean. There is a pipe blug on the side of that block, right next to the drive shaft. I would say the balls or whatever need to be insatlled through that hole. I hope I have helped.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Madison's County - by Anthony West. Philip Madison has been a good friend of mine for quite some time. He has patiently suffered my incessant chit chat on the subject of tractors for longer than I care to remember, and on many occasions he has put himself out, dropped what ever it was he was doing, to come and lend a hand cranking handles, or loading a find onto a trailer. Although he himself has never actually owned or restored a tractor, he was always enthusiastic and always around helping with other peoples projects.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.