I can help you with that question working for Eska Co. during production of the H pedal tractor. The first 50 of 100 with the Firestone tires were assembled with no holes drilled for cotter pin on front post axle and rear axle. Also ends of pedal crank were not threaded for hex nut end caps. Original plans for the H were designed for no holes using a flanged cap to secure the rims and rounded dome caps similar to the type used till mid 60's for the solid rubber pedals then changed after first 50 cast of the Firestone - International Harvester contract for cotter key and hex nut end caps till end of production of the all Eska H in late 1950. The tractor you have is very rare as I have not heard anything on this tractor with no holes in many many years. The value would be more than the red generic (which were to be the John Deere A) pedal tractor. Hope you find this information helpful.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.