John Deere Tractors Discussion Board|
JD 2010 Dozer
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by John A. Brownson on March 05, 2002 at 21:31:14 from (220.127.116.11):
I recently purchased a 2010 dozer. Within an hour or two of working it blew a head gasket. I fixed it and it operated well, but with disapointing power although I could uproot and push about mature manzanita. It seemed not to be able to back up any kind of decent slope. After retorquing the head and operating about 10 or so more hours it looks like the same thing is happening. I followed the manual exactly on torque pattern and went up in 5-10 foot-pound steps, used the copper gasket seal, cleaned things obsessively, where did I go wrong?
|Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]|
| Copyright © 1997-2014 Yesterday's Tractor Co.|
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor Headquarters