Thanks Everyone! It is amazing how many replies and ideas have been posted. I was able to get the gland nut out yesterday, I used a carbide bit in my Dremel and cut through in one place to the cast. Then I noticed a small piece had come loose from the cast and was able to use a small chisel. Once a small piece cam out the rest let loose! I tried using the Dremel and carbide bit on the broken drill bits but have not got them out yet. However, I think the holes are deep enough I don't need to get out what's left. I think I can use a shorter bolt and be ok. Any opinions? Just got a Snap On 140 mig welder. Used to weld for a living but that was 30 years ago and haven't welded since. Did some practicing yesterday. Not sure the welder is working right, but I know I forgot all I knew! I couldn't even do a spot weld on thin metal. Welded a bead ok on thick metal but thin metal just became a hole! LOL! Again, Thanks everyone! Bob
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Madison's County - by Anthony West. Philip Madison has been a good friend of mine for quite some time. He has patiently suffered my incessant chit chat on the subject of tractors for longer than I care to remember, and on many occasions he has put himself out, dropped what ever it was he was doing, to come and lend a hand cranking handles, or loading a find onto a trailer. Although he himself has never actually owned or restored a tractor, he was always enthusiastic and always around helping with other peoples projects.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
