Fixing this problem can be challenging. First thing I"d check is oil level. Make sure those oil pump gears on left side of crankcase are submerged as it may have lost its prime. If your oil pump gears are worn that can make it hard to get pressure as well. I bought my oil pump gears from Detwilers 4 years ago for $100 a set. Make sure oil suction pipe from bottom screen to oil pump isn"t cracked. (This pipe runs horizontally) Also, make sure your oil filter canister isn"t cracked or smashed from over tightening the filter nut, or has small pin holes. Mine had small pin holes nearest the casting wall from mouse urine. If its smashed from over tightening then the canister has to be removed & straightened. I"m assuming your tractor had been recently running? If so, get the oil level to flywheel side by jacking right side of tractor to submerge the oil pump gears for starters or add 2 or 3 quarts of oil. Some guys park them with right wheel higher for this reason. The oil pressure stick should raise while you hand crank the motor.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Oil Bath Air Filters - by Chris Pratt. Some of us grew up thinking that an air filter was a paper thing that allowed air to pass while trapping dirt particles of a particles of a certain size. What a surprise to open up your first old tractor's air filter case and find a can that appears to be filled with the scrap metal swept from around a machine shop metal lathe. To top that off, you have a cup with oil in it ("why would you want to lubricate your carburetor?"). On closer examination (and some reading in a AC D-14 service manual), I found out that this is a pretty ingenious method of cleaning the air in the tractor's intake tract.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
