Posted by jd50 puller on October 17, 2013 at 20:00:16 from (22.214.171.124):
In Reply to: g john deere posted by terhow on October 17, 2013 at 18:33:48:
Back then pto's were not standardized yet as with the different lifts such as the AC snap coupler, farmall's fast hitch or the john deere 800 & 801 or Yakima hitch. Mainly so if you purchased a certain brand you had to stick with their equipment. Most pto's were 1-3/8 but some were small or larger. I have a JD h and its smaller than 1-3/8. I have a friend with a G and a GM and the GM is larger. Also 540 was not a standard PTO speed either. I'm sure there are other reasons but that's all can put towards this at the moment. Someone correct or shed more light on this subject if I faltered in my information.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.