Posted by EricB on September 03, 2013 at 18:20:01 from (22.214.171.124):
In Reply to: 2-53 DETROIT ?'S posted by TIMAR on September 03, 2013 at 16:56:56:
If the timing is too advanced it will be hard to start. If it's retarded you get easier starting but more sluggish performance. This is less noticeable in a tractor than in a truck with a 53 series. It is vital that the timing pin settings are done with real accuracy as inaccuracy will contribute to unevenness in the firing cycle. The same goes for setting the racks. If the injectors were not replaced when the inframe was done they should be, they are very reasonable to buy. I have found the "1470" timing pin to be the best all round performer in my Detriots. The "1484" (more retarded) makes for easier starts but "doggy" for response.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.