Posted by farm mechanic on May 08, 2013 at 12:28:18 from (220.127.116.11):
I have a JD 2440, older SN, the problem that I am having is that the starter is turning very slow, and then dies, I have replaced the starter, batteries, cleaned the ground and batteries terminals. When I crank it over I get 3 or 4 turns than it stops, it I raise and lower the 3 pt hitch and all three of the loader valves It will crank over again and start. The other day after it started the hydraulics were chattering like it was low on fluid but I had just filled it, and the main filter was replaces a few months ago. I think someone said something about a bypass valve during that opens during start up, but I don't know where it is. Anybody have any ideas?
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.