Not exactly sure of a measurement but this tank is quite a bit less than 11" in height. Obviously, when your tractor showed up on the scene, JD had increased the tank capacity with a deeper tank, and then had to drop the height of the brackets (lower) which supported it, and at the same time they simplified the hold down hardware of the hood tin and went with some L-brackets spot welded to the inside of the hood. I'm guessing that your hood tin has a greater side height than the earlier ones with the slots in the side.
So what we have here is a JD D with the newer support brackets and the older tank and hood. So we need the older supports and the hold down clamps that are used for the older hoods with the side holes.
Same-Day Shipping! Most of our stocked parts ship the same day you order (M-F). Expedited shipping available, just call! Most prices for parts and manuals are below our competitors. Compare our super low shipping rates! We have the parts you need to repair your tractor. We are a Company you can trust and have generous return policies! Shop Online Today or call our friendly sales staff toll free (800) 853-2651. [ More Info ]
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.