Posted by Tim S on February 07, 2013 at 16:56:14 from (75.49.18.100):
In Reply to: Re: JD dune buggy posted by Mike M on February 07, 2013 at 13:40:26:
I have a few guys that keep an eye out for good ones,,I only use "good" ones, no rust, I get them with blown engines then put a new re-built one in, I rebuild them here, I buy some rusty ones for parts and engines. I strip them down and take care of the drive line and brakes, instal the cab back and some pieces to fill in body panels in the rear, then I send them to a paint shop and use an automotive Deere New Green paint copy, then I put the strips on using 3m decorative tape, and paint the wheels actual Deere Yellow. I have a metal shop shear and bend the beds, then I weld them up on a set-up stand, I have a Jig made up for the hoist sub frame. for the hydraulics I run a line from the power steering pump to a solenoid direction valve, the the bypass oil down to the steering box,I actuate the valve with a rocker switch in the cab for power up and down (drawing it down on a rubber strip to keep it from rattling),It will dump the bed full of #7 stone, i have a windshield guy put a piece of auto glass and an apolstery shop do the inside rear panel.They are nice when they are finished,,but I don"t make enough on them to make it worth while, i have only done 6 of them..
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Fire in the Field A hay fire is no laughing matter-well, maybe one was! And a good life-lesson, too. Following World War II many farm boys returned home both older and wiser. One such man was my employer the summer I was sixteen. He was a farmer by birth and a farmer by choice, and like many returning soldiers, he was our silent hero: without medals or decorations, but with a certain ability to survive. It was on his farm that I learned to use the combination hand clutch and brake on a John D
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.